Configure an Entire Floor (Router + Switch)
Take one floor of an office from bare metal to a working network: VLANs, access ports, port security, trunk, management and inter-VLAN routing.
Objectives
- ROUTER: set the hostname to 'Floor3-GW' and bring GigabitEthernet0/0 up; this physical link carries all four VLANs.
- ROUTER: build subinterfaces .10 .20 .30 .99 on G0/0, each tagged with its own VLAN and given its gateway: 10.3.10.1, 10.3.20.1, 10.3.30.1, 10.3.99.1, all /24, and up.
- SWITCH: set the hostname to 'Floor3-SW1' and create the VLANs 10 Sales, 20 Engineering, 30 Voice, 99 Management, with those names.
- SWITCH: Fa0/1-Fa0/2 in Sales, Fa0/3-Fa0/4 in Engineering, Fa0/5-Fa0/6 in Voice, each an enabled access port.
- SWITCH: port security on all six access ports, with sticky MAC learning on the four data ports (Sales and Engineering).
- SWITCH: make GigabitEthernet0/1 the trunk to the router, with native VLAN 99.
- SWITCH: management on Vlan99 at 10.3.99.2/24, and 'ip default-gateway 10.3.99.1'.
A hands-on Cisco CLI lab that runs in your browser.
More free labs
- VLAN Creation & Naming
- VLAN Trunking Mode
- EtherChannel LACP Clustering
- EtherChannel PAgP Clustering
- Spanning-Tree (STP) Basics
- Rapid Spanning-Tree (RSTP)
- STP Root Bridge Election
- Switchport Port Security
- Switch Management VLAN
- Layer 3 EtherChannel Bundle
- LACP Passive Mode Bundling
- Static EtherChannel With Mode On
- Multiple Spanning Tree Mode
- Root Bridge Primary and Secondary
- Access and Trunk Ports on One Switch
- Changing the Trunk Native VLAN
- Four Departmental VLANs
- Assigning Access Ports to a VLAN
- Hard-Coding Interface Speed and Duplex
- Switch Management VLAN and Default Gateway
- Rapid PVST With Deliberate Root Placement