Layer 3 EtherChannel Bundle
Build a routed LACP port channel between two multilayer switches and address it.
Objectives
- Enable IPv4 routing on the switch.
- Make GigabitEthernet0/1 and 0/2 routed ports in LACP channel-group 3, active mode.
- Make Port-channel3 a routed interface addressed 10.255.0.1 255.255.255.252.
A hands-on Cisco CLI lab that runs in your browser.
More free labs
- VLAN Creation & Naming
- VLAN Trunking Mode
- EtherChannel LACP Clustering
- EtherChannel PAgP Clustering
- Spanning-Tree (STP) Basics
- Rapid Spanning-Tree (RSTP)
- STP Root Bridge Election
- Switchport Port Security
- Switch Management VLAN
- Configure an Entire Floor (Router + Switch)
- LACP Passive Mode Bundling
- Static EtherChannel With Mode On
- Multiple Spanning Tree Mode
- Root Bridge Primary and Secondary
- Access and Trunk Ports on One Switch
- Changing the Trunk Native VLAN
- Four Departmental VLANs
- Assigning Access Ports to a VLAN
- Hard-Coding Interface Speed and Duplex
- Switch Management VLAN and Default Gateway
- Rapid PVST With Deliberate Root Placement