Access and Trunk Ports on One Switch
Configure an uplink trunk and two user access ports on the same switch.
Objectives
- Create VLAN 10 named 'Reception' and VLAN 20 named 'Clinical'.
- Make GigabitEthernet0/1 a trunk.
- Put FastEthernet0/1 in VLAN 10 and FastEthernet0/2 in VLAN 20 as access ports.
A hands-on Cisco CLI lab that runs in your browser.
More free labs
- VLAN Creation & Naming
- VLAN Trunking Mode
- EtherChannel LACP Clustering
- EtherChannel PAgP Clustering
- Spanning-Tree (STP) Basics
- Rapid Spanning-Tree (RSTP)
- STP Root Bridge Election
- Switchport Port Security
- Switch Management VLAN
- Configure an Entire Floor (Router + Switch)
- Layer 3 EtherChannel Bundle
- LACP Passive Mode Bundling
- Static EtherChannel With Mode On
- Multiple Spanning Tree Mode
- Root Bridge Primary and Secondary
- Changing the Trunk Native VLAN
- Four Departmental VLANs
- Assigning Access Ports to a VLAN
- Hard-Coding Interface Speed and Duplex
- Switch Management VLAN and Default Gateway
- Rapid PVST With Deliberate Root Placement