BuildTheNet

Opening your workspace

Your learning content and tools are loading.

EtherChannel

show etherchannel summary

Lists every port-channel with its protocol, its state flags and whether each member port is bundled.

Written by a working field network engineer · CCNA, Security+, CySA+

Lists every port-channel and its members with one- and two-letter flags. Learning to read those flags is most of EtherChannel troubleshooting: SU means a working Layer 2 bundle, P means a member is in it.

Example output

SW1#show etherchannel summary
Flags:  D - down        P - bundled in port-channel
        I - stand-alone s - suspended
        H - Hot-standby (LACP only)
        R - Layer3      S - Layer2
        U - in use      f - failed to allocate aggregator

        M - not in use, minimum links not met
        u - unsuitable for bundling
        w - waiting to be aggregated
        d - default port

Number of channel-groups in use: 1
Number of aggregators:           1

Group  Port-channel  Protocol    Ports
------+-------------+-----------+-----------------------------------------------
1      Po1(SU)         LACP      Fa0/7(P)    Fa0/8(P)

Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.

Useful variants

What each column or field means

FieldMeaning
Po1(SU)The port-channel and its state: S is Layer 2 (R would be Layer 3), U is in use. SD means it is down.
ProtocolLACP, PAgP, or a dash for static mode on.
(P)The member is bundled and passing traffic.
(I)Stand-alone: the port is up but did not join the bundle, usually because the far end is not negotiating.
(s)Suspended: the port’s configuration does not match the other members (speed, duplex, VLANs, trunk settings).
(D)The member port is down.

When it doesn’t look right

Po1(SD) with members (I).

Negotiation failed. Both ends passive (LACP) or both auto (PAgP) never form a bundle, and LACP cannot talk to PAgP. Set at least one end to active (LACP) or desirable (PAgP).

One member shows (s).

Its configuration differs from the others. Compare speed, duplex, access VLAN or trunk allowed list and native VLAN, and configure the port-channel interface rather than individual members.

Members go err-disabled when the channel comes up.

EtherChannel misconfiguration guard detected one side bundled and the other not, often mode on facing a negotiating port. Use LACP on both ends.

Related commands

Try it yourself

Learn it in the CCNA path

Topic

EtherChannel — Bundle parallel links into one logical port with LACP, PAgP or static mode, and read the summary flags to find a member that did not join.

All 57 commands