show interfaces status
Shows each switch port’s link state, VLAN, duplex, speed and media type in one table.
Written by a working field network engineer · CCNA, Security+, CySA+
The switch-port view of the world. Where show ip interface brief is about addresses, this table is about access ports: is the link connected, which VLAN is it in (or is it a trunk), and what speed and duplex did it negotiate.
Example output
SW1#show interfaces status
Port Name Status Vlan Duplex Speed Type
Fa0/1 connected 10 a-full a-100 10/100BaseTX
Fa0/2 connected 10 a-full a-100 10/100BaseTX
Fa0/3 disabled 1 auto auto 10/100BaseTX
Fa0/4 disabled 1 auto auto 10/100BaseTX
Fa0/5 disabled 1 auto auto 10/100BaseTX
Fa0/6 disabled 1 auto auto 10/100BaseTX
Fa0/7 connected trunk a-full a-100 10/100BaseTX
Fa0/8 connected trunk a-full a-100 10/100BaseTX
Gi0/1 connected 10 a-full a-1000 10/100/1000BaseTX
Gi0/2 disabled 1 auto auto 10/100/1000BaseTX
Po1 connected trunk a-full a-100Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.
Useful variants
sh int statusshow interfaces status err-disabledshow interfaces status | include notconnect
What each column or field means
| Field | Meaning |
|---|---|
Port | The short port name (Fa0/1, Gi0/1, Po1). |
Name | The interface description, truncated to fit. |
Status | connected, notconnect (no link), disabled (shut down) or err-disabled (shut by the switch for a violation). |
Vlan | The access VLAN, “trunk” for a trunk port, or “routed” for a Layer 3 port. |
Duplex / Speed | Configured or negotiated values. a-full and a-100 mean auto-negotiated; full and 100 without the a- mean hard-coded. A port with no link shows auto auto because nothing has been negotiated yet. |
Type | The port’s media type: 10/100BaseTX for FastEthernet, 10/100/1000BaseTX for copper Gigabit, or a transceiver type. A port-channel is logical and has none. |
When it doesn’t look right
A port shows err-disabled.
The switch shut it (port security, BPDU Guard, EtherChannel misconfiguration and others). Find the reason with show interfaces status err-disabled, fix the cause, then shutdown and no shutdown the port.
A host port shows the wrong number in the Vlan column.
The access VLAN is wrong. Set it with switchport access vlan <id> and confirm with show vlan brief.
Duplex shows a-half on a link you expect to be full.
Auto-negotiation failed, often because the other end is hard-coded. Configure both ends the same way; a duplex mismatch causes late collisions and slow transfers.
Related commands
- show ip interface brief
- show vlan brief
- show interfaces
- show interfaces status err-disabled
- show interfaces description
Try it yourself
- Assigning Access Ports to a VLAN (free)
- Hard-Coding Interface Speed and Duplex (free)
- Fixing a Duplex Mismatch (Pro)
- Correcting a Wrong Access VLAN (Pro)
Learn it in the CCNA path
- Read show interfaces status for link, VLAN and speed (2. Network Access)
- Read detailed interface output and set speed and duplex (2. Network Access)
- Read administrative and operational switchport mode (2. Network Access)
Topic
Switching Basics — How a switch learns MAC addresses, how to read interface status, and how to fix speed, duplex and administratively down ports.