BuildTheNet

Opening your workspace

Your learning content and tools are loading.

VLANs

show vlan brief

Lists every VLAN on the switch with its name, status and the access ports assigned to it.

Written by a working field network engineer · CCNA, Security+, CySA+

The quickest proof that a VLAN exists and that the right access ports are in it. It is the check after every switchport access vlan change.

Example output

SW1#show vlan brief

VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------
1    default                          active    Fa0/3, Fa0/4, Fa0/5, Fa0/6, Gi0/2
10   USERS                            active    Fa0/1, Fa0/2, Gi0/1
20   SERVERS                          active
99   MGMT                             active
1002 fddi-default                     act/unsup
1003 token-ring-default               act/unsup
1004 fddinet-default                  act/unsup
1005 trnet-default                    act/unsup

Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.

Useful variants

What each column or field means

FieldMeaning
VLANThe VLAN number (1 to 4094).
NameThe name set with the name command under the VLAN, or the default VLAN00xx.
Statusactive, or act/lshut and sus if the VLAN is shut down or suspended. act/unsup marks the legacy VLANs 1002-1005.
PortsAccess ports assigned to the VLAN, including shut ones. Trunk ports, here Fa0/7, Fa0/8 and Po1, are not listed; use show interfaces trunk for those.
1002-1005Default VLANs for FDDI and Token Ring, kept for compatibility. Every Catalyst switch has them, they cannot be deleted, and they count towards the VLAN total in show vtp status.

When it doesn’t look right

A port you configured is missing from its VLAN.

It is a trunk (trunks never appear here), or the access VLAN was set on a different port. Check show interfaces switchport for that port.

The VLAN you assigned does not appear at all.

Older IOS versions create the VLAN automatically when you assign a port to it, but some switches and VTP client mode do not. Create it with vlan <id> in global configuration.

Ports listed under VLAN 1 that should be elsewhere.

Unconfigured ports stay in VLAN 1. Assign them, or shut unused ports and park them in an unused VLAN.

Related commands

Try it yourself

Learn it in the CCNA path

Topic

VLANs — Create and name VLANs, assign access ports, and read the VLAN table to prove each port is in the broadcast domain you intended.

All 57 commands