show lacp neighbor
Shows the LACP partner seen on each member port: its system ID, port number and LACP flags.
Written by a working field network engineer · CCNA, Security+, CySA+
Shows what the switch hears from its LACP partner on each member port. If a port will not bundle, this tells you whether the other end is sending LACP at all, and with which system ID.
Example output
SW1#show lacp neighbor
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 1 neighbors
Partner's information:
LACP port Admin Oper Port Port
Port Flags Priority Dev ID Age key Key Number State
Fa0/7 SA 32768 0050.7966.6900 14s 0x0 0x1 0x108 0x3D
Fa0/8 SA 32768 0050.7966.6900 14s 0x0 0x1 0x109 0x3DReference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.
Useful variants
show lacp neighbor detailshow lacp 1 neighborshow lacp sys-id
What each column or field means
| Field | Meaning |
|---|---|
Flags | SA: the partner requests slow LACPDUs (every 30 seconds) and is in active mode. P would mean passive. |
Dev ID | The partner’s LACP system ID (its MAC). Every member must see the same Dev ID, or the links go to different switches. |
Age | Seconds since the last LACPDU was received on that port. |
Oper Key | The partner’s operational key, derived from its channel group. Must match across members. |
Port State | A bit field; 0x3D means active, aggregatable, in sync, collecting and distributing. |
When it doesn’t look right
No neighbor listed on a member port.
The far end is not running LACP on that port: it is set to mode on, to PAgP, or the port is not in a channel group.
Members show different Dev IDs.
The links land on two different switches that are not a stack or vPC/StackWise Virtual pair. They cannot form one bundle.
Related commands
Try it yourself
- EtherChannel LACP Clustering (free)
- LACP Passive Mode Bundling (free)
Learn it in the CCNA path
- Form an LACP EtherChannel (2. Network Access)
- Compare LACP active and passive and PAgP modes (2. Network Access)
- Bundle links and see why one flow stays on one (Prerequisite review: CCNA topics from the CCNP courses)
Topic
EtherChannel — Bundle parallel links into one logical port with LACP, PAgP or static mode, and read the summary flags to find a member that did not join.