Learning paths › CCNA › 2. Network Access
2. Network Access
The switched floor. VLANs and trunks, loop prevention, link aggregation, the discovery protocols that tell you what is plugged in where, and the wireless infrastructure that extends the same access layer without a cable.
Lessons
- Device Discovery (CDP & LLDP)
- Wireless Topologies & AP Modes
- Cisco WLC Configuration & WLAN Creation
- Layer 2 Switching
- VLAN Basics
- VLAN Trunking & 802.1Q
- DTP & VTP Protocols
- Spanning Tree (STP)
- STP Roles & States
- Rapid PVST+ & PortFast
- EtherChannel (Link Aggregation)
- Layer 3 Routed EtherChannels
- Cisco CLI Commands Sheet
- Reading the VLAN Table
- Read show interfaces status for link, VLAN and speed
- Describe ports and read one interface's configuration
- Shut down and re-enable a port
- Repair a disabled port with no shutdown
- Configure a range of ports at once and shut the unused ones
- Read detailed interface output and set speed and duplex
- Follow one ping through its Ethernet frame
- Predict whether a switch forwards, floods or filters
- See ARP resolve before the first ping
- Test same-VLAN and cross-VLAN reachability
- Treat a VLAN as a broadcast boundary
- Create and name a VLAN
- Build several VLANs with consistent names
- Repair missing or misnamed VLANs from show vlan brief
- Assessment: VLAN Creation
- Assign an access port to a VLAN
- Apply access settings to a range of ports
- Prove an access port works with a ping
- Repair the port in the wrong access VLAN
- Read administrative and operational switchport mode
- Assessment: Access Port Configuration
- Tell access ports from trunk ports
- Bring up an 802.1Q trunk
- Check a two-switch trunk end to end
- Add a VLAN to a trunk's allowed list
- Change the native VLAN on a trunk
- Repair a native VLAN mismatch
- Repair a trunk with mismatched allowed lists
- Assessment: 802.1Q Trunk
- Read the trunk table and see how a Layer 2 loop forms
- Read show spanning-tree to find the root and port roles
- Switch to Rapid PVST+
- Pin the root bridge with root primary and secondary
- Enable PortFast on edge ports
- Protect edge ports with BPDU Guard
- Bundle parallel links into one EtherChannel
- Form an LACP EtherChannel
- Compare LACP active and passive and PAgP modes
- Repair an EtherChannel mode mismatch
- Read the EtherChannel summary flags
- Assessment: LACP EtherChannel
- Assessment: VLANs
- Choose the STP protection that matches the failure