Learning paths › CCNA › 3. IP Connectivity
3. IP Connectivity
Getting traffic off the LAN. How a router picks a path, static and dynamic routes, OSPF, and tracing a flow end to end so you can name the exact hop it died at instead of guessing.
Lessons
- Life of a Packet
- Dynamic Routing Concepts
- RIP & EIGRP Protocols
- Routing Fundamentals
- Static & Default Routes
- Router-on-a-Stick & SVI
- IP Routing & OSPF
- OSPF Basics & Neighbor States
- OSPF Configuration & Network Command
- OSPF Cost Calculation & Tuning
- Multi-Area OSPF & Default Route Injection
- Set a host's IPv4 address, mask and gateway
- Read an address against its mask
- Size subnets with VLSM block sizes
- Route between VLANs with SVIs
- Read the routing table and add a default route
- Add static routes in both directions
- Extend static routing across a transit router
- Troubleshoot a failed ping by checking forward and return paths
- Break an IPv4 static routing loop
- Enable IPv6 routing and address an interface
- Add static IPv6 routes through a next hop
- Break an IPv6 static routing loop
- Build an interface ID with EUI-64
- Enable OSPF with network statements
- Separate OSPF adjacency from route advertisement
- Scale single-area OSPF across three routers
- Originate a default route into OSPF
- Add a floating static backup route
- Build a routed EtherChannel between routers
- Build a routed EtherChannel on a multilayer switch
- Assessment: Default Route
- Assessment: Single-area OSPF
- Two decisions: install the route, then forward the packet