Projects › Juniper SRX Branch Edge Gateway with Floating Static Default Route Failover
Juniper SRX Branch Edge Gateway with Floating Static Default Route Failover
Harbour Lane Wealth, a two-adviser financial office, has an SRX300 (EDGE-SRX) with two internet circuits: a fibre line from ISP-FIBRE (203.0.113.0/30) and a broadband backup from ISP-BROADBAND (198.51.100.0/30). Client video calls must keep working when the fibre drops. Address both circuits, make the fibre the preferred default route and the broadband a floating backup, and prove the backup takes over. The lab SRX forwards in packet-based mode, as an SRX deployed as a plain router does, so no security zones are needed here (proj-55 covers flow mode).
Difficulty: intermediate · Time: about 45 minutes
Why it matters
A backup circuit nobody has tested is a guess. In Junos a static route's preference (5 by default) decides which next hop wins; giving the backup a worse preference keeps it idle until the primary next hop disappears. It fails over when the fibre interface or its next hop goes away, not when the provider breaks further upstream; catching that needs RPM probes with ip-monitoring, which is the next step on a real deployment.
Technologies
- Juniper Junos
- Static Routing
- Floating Static Routes
- Route Preference
- Failover Testing
Related projects
- Multi-Area OSPFv2 Network with Area 0 Backbone & Stub Routing
- Branch-to-Cloud WAN Fabric Deployment via Cisco SD-WAN
- Route-Based Site-to-Site VPN: Tunnel Interface and eBGP, with IKEv2 Design
- WAN-Edge QoS for Voice and Video: Classify, Queue, Apply
- Cisco SD-WAN Direct Internet Access (DIA) with Enterprise Firewall
- Dual-Circuit Branch: Floating Static Failover with a Pinned Probe Route
- DMVPN Phase 3: Hub-and-Spoke with On-Demand Spoke-to-Spoke Tunnels
- EIGRP for a Three-Store Retailer: Authenticated Peering and Stub Branches