show ipv6 neighbors
Shows the IPv6 neighbor cache, the NDP equivalent of the ARP table, with each neighbor’s state.
Written by a working field network engineer · CCNA, Security+, CySA+
IPv6 uses Neighbor Discovery instead of ARP. This is its cache: which link-layer address belongs to each IPv6 neighbor, and whether the router has recently confirmed it is reachable.
Example output
R1#show ipv6 neighbors
IPv6 Address Age Link-layer Addr State Interface
2001:DB8:12::2 0 0050.7966.6816 REACH Gi0/1
FE80::250:79FF:FE66:6816 0 0050.7966.6816 REACH Gi0/1
2001:DB8:10::11 2 0050.7966.6817 STALE Gi0/0Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.
Useful variants
show ipv6 neighbors GigabitEthernet0/1
What each column or field means
| Field | Meaning |
|---|---|
Age | Minutes since the entry was last confirmed. |
State | REACH (recently confirmed), STALE (not confirmed lately; checked on next use), DELAY and PROBE (being verified), INCMP (no answer yet). |
When it doesn’t look right
An entry sits in INCMP.
The neighbor is not answering neighbor solicitations: wrong VLAN, interface down, or ICMPv6 filtered. Never block ICMPv6 wholesale; ND depends on it.
Related commands
Try it yourself
- IPv6 Interface Addressing (Pro)
- IPv6 SLAAC: Advertising a Prefix (Pro)
- Or build the example network in the free Sandbox
Learn it in the CCNA path
- Enable IPv6 routing and address an interface (3. IP Connectivity)
Topic
IPv6 — Enable IPv6 routing, address interfaces with global, link-local and EUI-64 addresses, and add IPv6 static routes.