show ipv6 interface brief
Lists every interface with its status and the IPv6 addresses on it, link-local first.
Written by a working field network engineer · CCNA, Security+, CySA+
The IPv6 counterpart of show ip interface brief. Each interface lists its link-local address first, then any global unicast addresses, so it is the quickest way to confirm both exist.
Example output
R1#show ipv6 interface brief
GigabitEthernet0/0 [up/up]
FE80::250:79FF:FE66:6812
2001:DB8:10::1
GigabitEthernet0/1 [up/up]
FE80::250:79FF:FE66:6815
2001:DB8:12::1
GigabitEthernet0/2 [up/up]
unassignedReference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.
Useful variants
show ipv6 interface GigabitEthernet0/0
What each column or field means
| Field | Meaning |
|---|---|
[up/up] | Interface status / line protocol, as in the IPv4 version. |
FE80::… | The link-local address, created automatically once IPv6 is enabled on the interface. Here it is EUI-64: the MAC 0050.7966.6812 with FFFE inserted in the middle and the seventh bit flipped (00 becomes 02). |
2001:DB8:… | Global unicast addresses configured or learned with SLAAC. The prefix length is not shown. |
unassigned | No IPv6 is enabled on that interface. |
When it doesn’t look right
Interfaces have addresses but the router does not route IPv6.
ipv6 unicast-routing is not enabled globally. Without it the router behaves as an IPv6 host.
Only a link-local address appears.
ipv6 enable is configured but no global address. Add ipv6 address <prefix>/<len> (or eui-64).
Related commands
Try it yourself
- IPv6 Interface Addressing (Pro)
- Enabling IPv6 Routing (Pro)
- Addressing Two IPv6 Interfaces (Pro)
- Dual-Stack on One Interface (Pro)
- IPv6 Address Autoconfiguration (Pro)
- Or build the example network in the free Sandbox
Learn it in the CCNA path
- Enable IPv6 routing and address an interface (3. IP Connectivity)
- Build an interface ID with EUI-64 (3. IP Connectivity)
Topic
IPv6 — Enable IPv6 routing, address interfaces with global, link-local and EUI-64 addresses, and add IPv6 static routes.