Learning paths › CCNA › 1. Network Fundamentals
Wireless RF & Frequencies
Master Radio Frequency (RF) basics: 2.4 GHz vs 5 GHz bands, non-overlapping channels (1, 6, 11), RF impairments (Absorption, Reflection, Attenuation), and dBm signal strength.
About 8 minutes
Why it matters
Many Wi-Fi complaints are really radio problems, such as overlapping channels or a weak signal. A basic grasp of RF lets you tell those apart from configuration faults.
The Physics of Wi-Fi Radio Waves
Wi-Fi uses radio waves in the 2.4 GHz and 5 GHz unlicensed ISM bands.
2.4 GHz penetrates solid obstacles better and travels further, but only has THREE non-overlapping 20 MHz channels: 1, 6, and 11.
5 GHz provides faster data rates and 24+ non-overlapping channels, but has shorter range and higher attenuation through walls.
RSSI (Received Signal Strength Indicator) is measured in negative dBm: -30 dBm is excellent, -67 dBm is minimum for voice, -85 dBm is unusable.
2.4 GHz vs 5 GHz Comparison
• 2.4 GHz: Longer wavelength (~12 cm). Superior wall penetration. Long range. Disadvantage: Extreme congestion (microwaves, Bluetooth) and only 3 clean channels (1, 6, 11).
• 5 GHz: Shorter wavelength (~6 cm). Attenuates rapidly through walls. Shorter range. Advantage: Massive bandwidth capacity, 24 clean non-overlapping 20 MHz channels, support for channel bonding (40, 80, 160 MHz).
The words you need
RF — Radio Frequency. Electromagnetic waves used for wireless communications.
2.4 GHz Band — Legacy Wi-Fi band (2.400 - 2.4835 GHz). Travels farther, but prone to interference and offers only 3 non-overlapping channels (1, 6, 11).
5 GHz Band — Modern Wi-Fi band offering greater bandwidth, less congestion, and 24+ non-overlapping 20 MHz channels.
Absorption — When radio waves pass into dense materials (concrete, drywall, water) and lose signal strength (attenuation).
Reflection — When radio waves bounce off metal surfaces, causing multipath distortion.
RSSI — Received Signal Strength Indicator. Signal power measured in negative decibel-milliwatts (-dBm).
Takeaways
- Compare the 2.4 GHz and 5 GHz bands.
- Explain why channels 1, 6 and 11 are used on 2.4 GHz.
- Read a signal strength in dBm and name the common RF impairments.
Next: IEEE 802.11 Standards & Wi-Fi Generations
More free lessons in 1. Network Fundamentals
- Network Fundamentals
- Network Devices
- Cables & Interfaces
- TCP/IP & OSI Models
- Switch Interfaces
- IPv4 Header
- IEEE 802.11 Standards & Wi-Fi Generations
- Cisco IOS CLI
- Ethernet Switching 1
- Ethernet Switching 2
- IPv4 Addressing
- IPv4 Configuration
- Subnetting Basics
- Finding Subnets Fast
- VLSM Subnetting
- IPv6 Addressing & Representation
- Network Diagnostics
- IPv6 Address Scopes & Types
- IPv6 Configuration & EUI-64