Projects › Home Office with an Isolated Guest Network
Home Office with an Isolated Guest Network
A two-person consultancy works from a converted garage. Clients visiting for meetings use the Wi-Fi, which today is the same flat network as the NAS holding every contract and the admin PC that runs the accounts. The router (OFFICE-GW) has its broadband handoff configured and nothing else; SW-1 is factory-fresh. Split the office into a CORP VLAN and a GUEST VLAN on one router-on-a-stick, hand out addresses by DHCP, get both onto the internet through the one public address, and stop guests reaching anything internal.
Difficulty: intermediate · Time: about 50 minutes
Why it matters
Small offices are breached through the shared network more often than through the internet connection. Segmenting a guest network with a VLAN, a filter and PAT is the smallest complete security design there is, and it is the same pattern every larger network uses.
Technologies
- VLANs
- 802.1Q Trunking
- Router-on-a-Stick
- DHCP
- NAT
- PAT
- Access Lists
- Guest Isolation
Related projects
- Edge Security Zone & DMZ Inspection with FortiGate
- Layer 2 Defense: DHCP Snooping, DAI, and IP Source Guard
- Zero-Trust 802.1X Port Authentication & Dynamic VLANs with Cisco ISE
- Enterprise Cyber Attack & Defense: Mitigating L2/L3 Exploits
- IPv6 First-Hop Security for a Campus Rollout: RA Guard and DHCPv6 Guard
- Enterprise Device Administration: Centralized TACACS+ with Cisco ISE
- Zero Trust Network Access (ZTNA): Micro-Segmentation via Zscaler ZPA
- Next-Gen Firewall Deep Packet Inspection: SSL/TLS & IPS with FortiGate