show version
Shows the software version, uptime, image file, memory, interface count and configuration register.
Written by a working field network engineer · CCNA, Security+, CySA+
Hardware and software facts about the device: software version, uptime, how it last restarted, the image file, memory, interface count and the configuration register. The example is SW1, an eight-port Catalyst 2960-Plus with two Gigabit uplinks.
Example output
SW1#show version
Cisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 15.0(2)SE11, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2017 by Cisco Systems, Inc.
ROM: Bootstrap program is C2960 boot loader
SW1 uptime is 2 hours, 14 minutes
System returned to ROM by power-on
System image file is "flash:/c2960-lanbasek9-mz.150-2.SE11.bin"
cisco WS-C2960+8TC-L (PowerPC405) processor (revision B0) with 131072K bytes of memory.
Last reset from power-on
1 Virtual Ethernet interface
8 FastEthernet interfaces
2 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
64K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:50:79:66:68:00
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 10 WS-C2960+8TC-L 15.0(2)SE11 C2960-LANBASEK9-M
Configuration register is 0xFReference output: hand-written in standard Cisco IOS format for this example network, not captured from a device. Shortened: the compile date, boot loader version, serial number and hardware assembly lines are left out.
Useful variants
sh vershow version | include uptime|register
What each column or field means
| Field | Meaning |
|---|---|
Version | The IOS release running. |
uptime is | Time since the last reload. An unexpectedly short uptime means the device restarted. |
System returned to ROM by | Why it last restarted: power-on, reload, or a crash reason. |
System image file | The IOS image the device booted from. |
memory / interfaces | Installed memory and the number and types of physical interfaces: SW1’s 8 FastEthernet and 2 Gigabit ports. The Virtual Ethernet interface is the VLAN 1 SVI; port-channels are not counted. |
Base ethernet MAC Address | The switch’s base MAC. Spanning tree uses it in the bridge ID, which is why SW1 appears as 0050.7966.6800 on the STP pages. |
Configuration register | On a router, 0x2102 is normal (boot from flash, load startup-config) and 0x2142 skips the startup-config for password recovery. Catalyst switches such as SW1 show 0xF and recover passwords from the boot loader instead. |
When it doesn’t look right
Configuration register is 0x2142 on a router.
The router will ignore its saved configuration on every boot. After password recovery set config-register 0x2102 and save.
Uptime is a few minutes and nobody reloaded it.
Check “System returned to ROM by” for the reason (power, crash), and the logs.
Related commands
Try it yourself
- Switch Management VLAN (free)
Learn it in the CCNA path
- Cisco CLI Commands Sheet (2. Network Access)
Topic
Device Management — Read the configuration and software version, save changes, discover neighbors with CDP and LLDP, and check logging and time.