Learning paths › Juniper Pro › Static routing, OSPF and IS-IS
Static routing, OSPF and IS-IS
Static routing with summarisation, martians, several installed next hops and a routing instance chosen from packet fields, then the two link-state IGPs in detail — OSPF's five packet types, the walk from Down to Full, LSA scope and an external route in a multi-area database, and IS-IS's levels, NET and database sync — closing on BGP's four message types and how a best path is chosen.
Lessons
- Install reachability by hand and summarise it
- Reject address space that should never be routed
- Keep two customers' routes apart, then share some
- Install several next hops and actually use them
- Choose a routing instance from packet fields
- Read where each route in inet.0 came from
- Separate the topology database from the routing table
- Name the five OSPF packets and what each does
- Walk a neighbour from Down to Full
- Cut flooding on a multi-access link
- Place a router by the areas it touches
- Read an LSA and know how far it travels
- Watch an external route enter a multi-area database
- Carry IP reachability over an OSI-born protocol
- Sync a database with Hellos, LSPs and SNPs
- Bring up Level-1 and Level-2 adjacencies
- Design levels so each area stays small
- Give the router a NET and ISO-enable its links
- Confirm levels, metrics and adjacency from show output
- Connect two areas with Level-1/Level-2 routers
- Advertise reachability between autonomous systems
- Read OPEN, UPDATE, KEEPALIVE and NOTIFICATION
- Tell a transport problem from a protocol disagreement
- Work out which path BGP will actually use