Learning paths › JNCIA-Junos › Routing policy, switching and the IGPs
Routing policy, switching and the IGPs
Junos switching objects — access and trunk ports, an irb gateway, root election, BPDU, root and loop protection, bridge domains and a stacked provider tag — then dynamic routing worked up from RIP's hop count through single- and multi-area OSPF to IS-IS levels and the NET, with adjacency authentication and BFD on both link-state protocols.
Lessons
- Trace a usable path from policy to forwarding action
- Apply the Ethernet model to Junos switching objects
- Configure access and trunk interfaces on a VLAN
- Give each VLAN a gateway on the switch
- Elect a root bridge and pick the root ports
- Apply BPDU, root and loop protection where each fits
- Bridge on MX with bridge-domains instead of vlans
- Stack a provider tag over a customer VLAN
- Match a Layer 2 requirement to the right Junos object
- Learn dynamic routing on the simplest protocol
- Count hops and know when 16 means unreachable
- Put interfaces in a RIP group and export routes
- Interoperate RIPv2 across vendors
- Separate wire behaviour from local configuration defaults
- Build up from one area to authenticated multi-area OSPF
- Bring up OSPF neighbours in one area
- Split topology detail with an ABR
- Authenticate adjacencies and detect failure faster
- Advertise a loopback two different ways and compare
- See how IS-IS differs from OSPF in transport and identity
- Build a NET and enable ISO on the links
- Connect area reachability to the Level-2 backbone
- Authenticate Hellos and LSPs at the right scope
- Link identity, transport family and level design
More in JNCIA-Junos
- The Junos Prompt
- Networking Groundwork
- How Junos Is Built
- Ways In
- Staging Changes
- Watching A Live Device
- Routing Foundations
- Policy And Filters
- Past The Exam
- Networking fundamentals and Junos architecture
- The CLI, the candidate configuration and initial setup
- Monitoring, maintenance and routing fundamentals
- BGP on Junos