BuildTheNet

Opening your workspace

Your learning content and tools are loading.

HSRP (First-Hop Redundancy)

show standby

Shows each HSRP group in detail: virtual IP and MAC, timers, priority, preemption and which router is active.

Written by a working field network engineer · CCNA, Security+, CySA+

HSRP in full for each group: the virtual MAC in use, hello and hold timers, priority and preemption, and when the state last changed. Use it after a failover to see what happened. As on show standby brief, the second router (192.168.10.3) and the virtual IP 192.168.10.254 extend the example network for the HSRP pages only.

Example output

R1#show standby
GigabitEthernet0/0 - Group 10
  State is Active
    2 state changes, last state change 00:12:41
  Virtual IP address is 192.168.10.254
  Active virtual MAC address is 0000.0c07.ac0a (MAC In Use)
    Local virtual MAC address is 0000.0c07.ac0a (v1 default)
  Hello time 3 sec, hold time 10 sec
    Next hello sent in 1.024 secs
  Preemption enabled
  Active router is local
  Standby router is 192.168.10.3, priority 100 (expires in 9.312 sec)
  Priority 110 (configured 110)
  Group name is "hsrp-Gi0/0-10" (default)

Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device.

Useful variants

What each column or field means

FieldMeaning
state changes, last state changeHow often and how recently this router changed role.
virtual MAC 0000.0c07.acXXHSRPv1 uses 0000.0c07.ac followed by the group number in hex (10 is 0a). HSRPv2 uses 0000.0c9f.fXXX.
Hello time / hold timeDefaults 3 and 10 seconds. The standby takes over when the hold time expires without hellos.
Priority (configured)Current priority and the configured one. They differ when interface tracking has lowered it.

When it doesn’t look right

Priority is lower than configured.

A tracked object (an uplink or an IP SLA) is down and decremented the priority. That is HSRP doing its job; check the tracked uplink.

State changes keep increasing.

Hellos are being lost intermittently. Look for an overloaded link or interface errors between the routers.

Related commands

Try it yourself

Topic

HSRP (First-Hop Redundancy) — Give hosts a virtual default gateway shared by two routers, control which one is active with priority and preemption, and verify failover.

All 57 commands