BuildTheNet

Opening your workspace

Your learning content and tools are loading.

Port Security

show errdisable recovery

Shows which err-disable causes recover automatically, the recovery timer, and ports waiting to recover.

Written by a working field network engineer · CCNA, Security+, CySA+

By default an err-disabled port stays down until someone bounces it. This shows which causes are set to recover automatically, how long the timer is, and any port currently counting down.

Example output

SW1#show errdisable recovery
ErrDisable Reason            Timer Status
-----------------            --------------
arp-inspection               Disabled
bpduguard                    Disabled
channel-misconfig (STP)      Disabled
dhcp-rate-limit              Disabled
dtp-flap                     Disabled
gbic-invalid                 Disabled
inline-power                 Disabled
link-flap                    Disabled
mac-limit                    Disabled
loopback                     Disabled
pagp-flap                    Disabled
port-mode-failure            Disabled
pppoe-ia-rate-limit          Disabled
psecure-violation            Disabled
security-violation           Disabled
sfp-config-mismatch          Disabled
small-frame                  Disabled
storm-control                Disabled
udld                         Disabled
vmps                         Disabled
psp                          Disabled

Timer interval: 300 seconds

Interfaces that will be enabled at the next timeout:

Reference output: hand-written in standard Cisco IOS format for this example network, not captured from a device. The list of causes varies a little between platforms and IOS releases. Nothing is listed under the last heading because no cause is set to recover, so an err-disabled port such as Fa0/2 waits for someone to bounce it.

Useful variants

What each column or field means

FieldMeaning
ErrDisable Reason / Timer StatusEach cause and whether automatic recovery is Enabled or Disabled for it.
Timer intervalSeconds before an err-disabled port is re-enabled. 300 by default; change it with errdisable recovery interval.
Interfaces that will be enabledA table of ports waiting to recover, with the cause and the seconds left. Empty when no err-disabled port has recovery enabled for its cause.

When it doesn’t look right

A port recovers, then goes err-disabled again every five minutes.

Automatic recovery is hiding a cause that is still there. Find and fix it rather than lengthening the timer.

No causes are enabled.

That is the default. Enable the ones you want, for example errdisable recovery cause psecure-violation.

Related commands

Try it yourself

Learn it in the CCNA path

Topic

Port Security — Limit which MAC addresses an access port accepts, choose a violation action, learn sticky addresses and recover err-disabled ports.

All 57 commands